How to make an incubator out of these materials?

GeckoGrace

Member
Messages
91
Location
Northern Illinois
I have a Zoo-Med Reptitherm UTH for heat (I'm incubating for a female). I'm using Perlite as a substrate and know the perfect humidity ratio. Apparently you can't use UTH's on plastic, and apparently they get REALLY hot. So how can i make this work?
 

J&M UNE

New Member
Messages
102
Location
brainerd mn
Every uth heater should be hooked up to a thermostat to control the temp..a uth pluged into a wall get upwards of 120 degrees. I have use Styrofoam coolers and flex watt ran of a herpstat thermostat. All my racks are plastic tub ran off of flexwatt controlled by herpstat theromstat

Sent from my Z936L using Tapatalk
 
Top